Tag SOLIDWORKS

Rear Wing Mounting & Structure

With the reaction forces obtained from the analysis above, component-wise design commenced. In the case of the two brackets, it is apparent that one bracket will be loaded more than the other in the instance of cornering.

E2 Powertrain Mounting & Brackets

The above design were particularly heavy & I believed we could obtain a better solution. Analyzing commercial car chassis, I was inspired to proceed with a design reinforced with ‘bend’s. The final design was only half the thickness of the…

Gearbox design for a Screw Expeller

The selected module of 16mm was derived as the closest approximation from the available standard module sizes. Static loads & Dynamic loads were determined based on the determined gear ratio & module for each of the gear pairs, following which…